The Conclusions and Recommendations can be combined or, in long reports, presented in separate sections.

The Conclusions and Recommendations can be combined or, in long reports, presented in separate sections.

Conclusions and recommendations

If there are not any recommendations to be made as a consequence of the project, call this section just Conclusions.

The Conclusions section sums up the important thing points of the discussion, the essential features of your design, or perhaps the significant outcomes of the investigation. As the function is to round the story off of your project, it should:

  • be written to relate directly to the aims for the project as previously mentioned into the Introduction
  • indicate the extent to that your aims have already been achieved
  • summarise the findings that are key outcomes or information in your report
  • acknowledge limitations and then make recommendations for future work (where applicable)
  • Highlight the usefulness or significance of your work.

The conclusions should connect with the aims regarding the work:

The aim of this project would be to design a cell phone tower for a suburban location..

The cellular phone tower presented here may be erected safely in a suburban street.

It takes a complete area of a maximum of 2m 2 l, and has now the following safety features.

This investigation will review the quantity of passengers using the Monash University Clayton-Caulfield inter-campus bus to be able to recommend adjustments to the service if needed.

Analysis associated with the survey data obtained in this project indicates that use of the Clayton-Caulfield inter-campus bus has increased by 24% in past times five years. It is suggested that frequency be increased during peak usage.

The Conclusions section below is from a known level 2 Civil Engineering Alternative Designs report presenting two designs for a an overpass bridge. Click on the coloured buttons to look at comments.

Conclusions

Each one of the two bridge designs Lecturer’s comment:
An elegant beginning for a Conclusions follows on neatly from the preceding discussion. In this case, in addition it indicates that the aims associated with project have now been met. presented in this report fulfil the criteria specified into the project brief. Both designs Lecturer’s comment:
The main findings or outcomes – in this full case the important thing features of the designs – are then recapped. incorporate round piers on piled foundations, which are used as the soil conditions are unknown and possibly unstable. Design 1, a simple composite I-girder bridge, has got the advantageous asset of being manufactured from steel and thus has longer spans and fewer piers.

Design 2, a super-T beam br >Design 2 Lecturer’s comment:
The significance of the outcome – in this situation the ultimate recommendation – is actually stated. is therefore recommended. It offers Lecturer’s comment:
To finish off, the achievement for the project is reinforced. a reasonable overpass with superior durability, and fully meets certain requirements of this design brief.

Always address limitations and suggest how they may be overcome in the future work. The excerpt below is through the Conclusions of a study on a project investigating the effect of pulsation on heat transfer in horizontal pipe flow.

Experimental results Lecturer’s comment:
Key conclusions drawn from the project. showed that pulsed flow without flow reversal had no effect that is significant with steady flow. Preliminary experiments with reversed flow, however, clearly indicated increased heat transfer. That is likely due Lecturer’s comment:
Provide a explanation that is possible notable results, especially unexpected ones. towards the large disturbances into the boundary that is hydrodynamic if the flow changes direction. Further research Lecturer’s comment:
Recommend further research to deal with any work that is extra think could be useful. is recommended to determine the utmost achievable enhancement.

It should be noted that Lecturer’s comment:
Acknowledge limitations or errors and suggest explanations solutions that are and/or. the experimental results usually do not concur with the equations that are theoretical. This might be as a result of deposits which developed in the pipe, or to inconsistent thermocouple temperature. Therefore, regular inspection of this test rig is recommended.

For a tremendously long report, it is acceptable to present the conclusions essay writer and recommendations in point form:

The prototype robot courier presented here has been shown to allow you to delivering documents autonomously in an working office environment. It has demonstrated listed here aspects of mobile robotics:

  1. Localisation: The Kalman filter-based localisation algorithm achieved sub-centimeter accuracy under normal operating conditions.
  2. Environment modelling: The occupancy map was updated dynamically to include obstacles not within the map that is original.
  3. Path planning: A distance path that is transform-based using obstacle transforms produced a globally optimal local entrapment-free way to the goal.